Installation and Setup Guide
5-6
PROMPT
VALID ENTRIES EXPLANATION
XMIT TO CONFIRM
PRESS ✱ TO SKIP
Confirmation Option
Activate the loop input or button
[∗] to continue
This prompt will only appear if you answered
“Yes” at the first prompt in this section.
The system will enter a confirmation mode so that
the operation of the actual programmed input can
be confirmed.
Activate the loop input or button that corresponds
to this zone.
If the serial number and/or loop number
transmitted does not match the serial number
entered, a display similar to the one below appears.
Entd A022-4063 1
Rcvd A022-4064 1
If so, activate the loop input or button on the
transmitter once again. If a match is not obtained
(i.e., summary display does not appear), press the
[#] key twice and then enter (or transmit) the
correct serial number.
Press [∗] to continue.
Zn ZT RC In: L
17 03 10 RF: 1s
Summary Screen
[∗] to continue
If the serial number transmitted matches
the serial number entered, the keypad will
beep 3 times and a summary display will
appear, showing that zone's programming.
Note that an “s” indicates that a
transmitter’s serial number has been
enrolled.
Press [∗] to accept the zone information and
continue.
PROGRAM ALPHA?
0 = NO 1 = YES 0
Alpha Descriptors
0 = no
1 = yes
[∗] to continue
If you want to program descriptors for zones now,
enter 1 (Yes) and refer to the Alpha Descriptor
Programming section for the procedure to use.
ENTER ZN NUM.
(00 = QUIT) 11
Next Zone Number
00 = quit
[∗] to continue
If 0 (No) was entered above, the system will return
you to the ENTER ZN NUM. prompt for the next
zone.
When all zones have been programmed, enter 00
to quit.
To Next Page
Loading...
