Installation and Setup Guide
5-12
PROMPT
VALID ENTRIES EXPLANATION
Entd A022-4063
Rcvd A022-4064
Not Confirmed
[∗] to continue
If the serial number transmitted does not match the serial
number entered, a display similar to the one shown will
appear. If the loop number does not match, it will also be
displayed.
If so, activate the button on the wireless key once again. If a
match is not obtained (i.e., summary display does not
appear), press the [#] key and then enter the correct serial
number.
If the serial number transmitted matches the serial number
entered, the keypad will beep 3 times and will return you to
step 8 to enter the starting zone for the next wireless key.
NOTE: Following the successful enrollment of each
wireless device, remove ONE of the serial number labels
from the device and affix it in the appropriate column on
the ENROLLED TRANSMITTERS worksheet of the
Programming Form; then enter the other information (zone
number, zone type, loop number, etc.) relevant to that
device.
Wireless Key Predefined Default Templates
5804 Wireless Key Transmitter
5804BD 2-Way Wireless Key Transmitter
5804 5804BD
Template 1 Loop Function Zone Type Template 4 Loop Function Zone Type
1 No Response 23 1 No Response 23
2 Disarm 22 2 No Response 23
3 Arm AWAY 21 3 Arm AWAY 21
4 No Response 23 4 Disarm 22
Template 2 Loop Function Zone Type Template 5 Loop Function Zone Type
1 No Response 23 1 No Response 23
2 Disarm 22 2 Arm STAY 20
3 Arm AWAY 21 3 Arm AWAY 21
4 Arm STAY 20 4 Disarm 22
Template 3 Loop Function Zone Type Template 6 Loop Function Zone Type
1 24-Hour Audible 07 1 24-Hour Audible 07
2 Disarm 22 2 Arm STAY 20
3 Arm AWAY 21 3 Arm AWAY 21
4 Arm STAY 20 4 Disarm 22
To Next Page
Loading...
