Exhaust Gas Collector for Diverting Output or Collecting Gas
Samples
Diverting output gas or collecting samples requires an Exhaust Gas Collector assembly (P/N:
W01-3020-000), which includes the Gas Collector Plate and these parts: a male luer connector
(P/N: 400-0073-000) and Tygon tubing (P/N: 411-0018-037). Capturing samples requires a
Tedlar sample collection bag (3 liters, P/N: 500-0003-000).
Note: When collecting samples for evidence or later analysis, it is recommended to use only the
PID sensor.
Important! Remove the Exhaust Gas Collector after capturing samples. Do not leave the Exhaust
Gas Collector attached during continuous monitoring.
AreaRAE 119 User Manual
To Next Page
Loading...
