Menus and Submenus
In Programming Mode, menus and submenus are organized as shown here:
Calibration Measurement Alarms Datalog Wireless Monitor
Fresh Air Sensor On/Off Alarm Limits Clear Datalog
Sel Primary
Radio
LCD Contrast
Multi Sensor Span
Change Meas.
Gas
Alarm Mode Datalog Interval GPS Zero At Start
Single Sensor Zero
Measurement
Unit
Alarm
Settings
Sensor Selection Mesh Fast Startup
Single Sensor Span
Comfort
Beep
Data Selection ISM Language
Multi Sensor Bump Datalog Type Wi-Fi Site ID
Single Sensor Bump
Memory Full
Action
Message* User ID
Cal. Reference
Secure In
Place
Change Cal. Gas
Multi Cal. Select
Change Span Value
Change Span 2
Value**
* “Message” menu item appears only when messages have been received by the AreaRAE
Plus/Pro.
** 7R+ sensors and 4R+ ppb sensors
Editing and Selecting Parameters and Sensors
There are a few basic ways to edit parameters, select sensors, and perform other activities in the
AreaRAE Plus/Pro. The actions performed by pressing keys always match 1-to-1 with the boxes
along the bottom of the display and the three keys. Some parameters are edited by scrolling and
selecting individual items (black bars behind white text act as highlighters). Some include a
choice via “radio buttons,” where only one item in a list can be selected, while other menus use
boxes for you to “check” with an “X,” and these allow for multiple items in a list to be selected. In
all cases of editing, you can save or undo your choice.
AreaRAE 53 User Manual
To Next Page
Loading...
Need help?
General
