Programming
The menu in Programming Mode is to adjust settings, and calibrate sensors. It has the following
submenus:
l Measurement
l Alarms
l Datalog
l Wireless
l Monitor
l Calibration
Enter Programming in Basic Mode
Programming in Basic Mode is limited to calibration only. A password is required to access
other programming menus.
1. To enter Programming Mode, press and hold [MODE] and [N/-] until you see the
Password screen.
2. Input the 4-digit password:
l Increase the number from 0 through 9 by pressing [Y/+].
l Step from digit to digit using [N/-].
l Press [MODE] when you are done.
AreaRAE 50 User Manual
To Next Page
Loading...
