Honeywell BCU 465 - Scanning the Parameters

BCU 460, BCU 465 · Edition 11.19 72
Parameters
11.3 Scanning the parameters
During operation, the four-digit 7-segment display
shows the program step/status.
In addition to the flame signal and the fault history, all
the parameters of the BCU can be scanned in numeri-
cal order by repeatedly pressing the Reset/Information
button (for 1s).
The parameter display is ended 60seconds after the
last time the button is pressed or by switching off
theBCU.
The BCU indicates
when the mains switch has been
switched off. The parameters cannot be scanned when
the BCU is switched off or when a fault or warning is
displayed.