Honeywell CGW-MB - 2: to Activate the Bacnet Support

CGW-MB Installation and Users’ Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022
114
BACnet Feature Activation The BACnet Feature
7. Scroll down to find BACnet Support in the Features tab.
8. Enter the number of support required in the BACnet Support field.
9. Click PURCHASE.
10.Read the Confirmation message and if acceptable, click CONFIRM.
Or
Click CANCEL and repeat the steps from 8 to 10.
11.Wait for the purchase to complete and refresh the page, if required.
12.Verify that the purchased number under Available Features is correct.
8.8.2 To Activate the BACnet Support
1. Tap Perform Feature Activation on the CLSS App’s welcome message.
Figure 8.5: Feature Activation: The First Step
2. Tap Fixed CLSS Gateway mainboards.
3. Select the site of the CLSS Gateway mainboard.
4. Find and tap the OC of the CLSS Gateway mainboard.
5. Tap ADD ACTIVATION.
6. Tap BACnet Support under the One Time Activations.
7. Tap ACTIVATE.
8. Wait for the activation successful message.
NOTE:
- The CLSS Gateway mainboard must be already installed. If not, install the fixed CLSS
Gateway mainboard.
- All the network settings should be configured while installing.