CGW-MB Installation and Users’ Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022 30
Honeywell CLSS Alarm Transmission Services Configurations
Install a Fixed CLSS Gateway mainboard at the Site
To enable central station communications, a CGW-MB must be installed.
1. Log into the Connected Life Safety Services App in your mobile device.
2. Tap the three horizontal dots icon at the top-right side on the All Customers
dashboard.
3. Select Install Fixed CLSS Gateway mainboard from the pop-up menu.
4. Follow the on-screen instructions to complete the CLSS Gateway mainboard
installation in the App.
Configuring the Central Station Communication
A technician or a service provider administrator can configure the central station
communication of the CGW-MB.
1. Log onto the CLSS Site Manager.
2. Select the customer from the All Customers list at the top-left side.
3. Select the customer, select the site, and then select the building requiring alarm
transmission.
4. Click the FEATURE ACTIVATION icon at the left navigation bar.
5. Select Installed CLSS Gateway mainboards and then go to the INSTALLED CLSS
Gateway mainboardS section.
NOTE: You can skip this procedure if you are activating the central station
communication for a CGW-MB that is already installed.
THE FEATURE ACTIVATION ICON
NOTE: To view only those CLSS Gateway mainboards not yet activated, select Show only
CLSS Gateway mainboards without activations at the right side.
To Next Page
Loading...
