Honeywell CGW-MB - C.13.3: Programming for Annunciator (ANN-PRI); C.13.4: to Program for Annunciator

CGW-MB Installation and Users’ Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022 183
Triga Panels Connecting to the Panels
C.13.3 Programming for Annunciator (ANN-PRI)
Programming enables the panel to recognize the CGW-MB and the annunciator.
C.13.4 To Program for Annunciator
Using the keypad on the panel, you select options on the screens.
1. On the panel, press the Enter button on the keypad.
2. View the panel screen options.
3. On the keypad, press 7 to select 7 = PROGRAMMING MODE .
4. Enter the panel's password in the PROGRAMMING screen.
The default password is: 00000000
5. Select the panel connected with the CLSS Gateway mainboard, if it is a standalone
panel.
OR
Navigate in the list of panels and select the panel connected with the CLSS Gateway
mainboard if it is a multi-panel network.
6. Select 1 = MODULE .
7. Select 2 = ADD MODULE .
8. Select the module of the CLSS Gateway mainboard from the list.
9. Select the module type.
10.Select 1 = EDIT MODULE to enter the module details.
11.Follow the on-screen instructions and enter the communication settings.
12.Review the entered details.
!
CAUTION: BEFORE PROGRAMMING, ENSURE THAT THE ANN-PRI COMMUNICATION CABLE IS
CONNECTED WITH THE PANEL.