Honeywell CGW-MB - Installation and Configurations; The IP Settings; To Connect with the Modbus Client

CGW-MB Installation and Users’ Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022 49
Installation and Configurations Modbus Communications
7.13 Installation and Configurations
The CGW-MB can communicate with the Modbus client in an Ethernet LAN.
7.14 The IP Settings
The following information applies to IP settings:
• You can use only the eth1 port for connections to Modbus clients. For more details,
refer to
7.16 "To Configure the Modbus Settings"
.
• Each CGW-MB is shipped with a default node number of 235.
• The computer used to configure the CGW-MB must establish an IP connection to the
CLSS Gateway mainboard. Consult with a network administrator if unsure how to
make this connection.
• Connecting more than one CGW-MB prior to reconfiguring the IP address will result in
an IP address conflict.
7.15 To Connect with the Modbus Client
1. At the CGW-MB side, connect an Ethernet cable to the Ethernet Port 1.
2. At the Modbus client side, connect the other end of the Ethernet cable to the system
running the Modbus client.
Fire Alarm Panel
CLSS
Cloud
Modbus
Client
Configuration
Computer
Mobile
Connection
/NUP
Ethernet
Connection
WHITE COLOR
GREEN COLOR
RED COLOR
BLACK COLOR
BROWN COLOR
P7
P2
P4
J5
P1
RS485 A
Future Use
RS485 B
(
Eth 1
)
(
Eth 0
)