CGW-MB Installation and Users’ Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022 27
Verifying the CLSS Gateway mainboard Connections Configurations
5.2 Verifying the CLSS Gateway mainboard Connections
While configuring the CLSS Gateway mainboard, confirm that the LEDs indicate
successful connections as shown in Figure 5.3.
If the LED is indicating differently, refer to Table 2.2 to know the operational status. If
necessary, refer to the 6.2, "Troubleshooting" section to fix the problem or contact
Honeywell Technical Support.
LED Indicator State Meaning
Power-Indicating LED ON Successful power connection
DL1 ON
OFF
ON - The cellular module is installed and
receiving power.
OFF - The cellular module is not installed.
DL2 OFF There are no issues
DL6
Flashing fast
a
Successful mobile connection
Flashing slow
b
Ready for connection
OFF Disabled mobile connection
DL3 ON The CLSS Gateway mainboard is in the configuration
mode
Flashing fast The CLSS Gateway mainboard is getting the
inventory data
Flashing slow The CLSS Gateway mainboard is communicating
with the panel
To Next Page
Loading...
