CGW-MB Installation and Users’ Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022 146
ESSER Panels Connecting to the Panels
On the Panel Side
• Connect the +ve wire to the +Ub pin of the power supply module.
• Connect the -ve wire to the Gnd pin of the power supply module.
•
Figure C.8: FlexES Panel Power Connectors
Tools 8000 Settings for FlexES Panels
1. Select the Serial Interfaces tab in Tools 8000.
2. Go to the Serial Interface 1 section.
3. Select WINMANG from the Device in use list.
4. Go to the Serial Interface 3 section.
5. Select Remote Access from the Device in use list.
6. Click OK.
To Next Page
Loading...
