CGW-MB Installation and Users’ Manual | P/N:LS10248-000HW-E | REV.G | JUL/31/2022 168
Gent Panels Connecting to the Panels
1. On the CLSS Gateway mainboard Side
1. Connect the RS-232 cable to the RS-232 port of the CLSS Gateway mainboard.
The RS-232 port is labeled as 6 in the Figure C.2.
2. On the Panel Side
1. Inside the panel enclosure, find the backplane PCB board.
2. Insert the I/O card into the P2 Card 15.
Figure C.22: Vigilon Panels: I/O Card Connection
For the P2 Card 15-Connected I/O Card:
1. In the panel, find the RS-485/RS-232 (P4) connectors on the main control board.
2. Connect the RS-232 cable to the Tx (Brown), Rx (White), and 0V (Green) terminals
of the RS-485/RS-232 (P4) connectors.
To Next Page
Loading...
