Honeywell CIU 888 - Page 101

Getting Started
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 3 - 71
$*6
10.Click the Vapour Pressure tab, the Properties detail appears.
You can view or edit these properties:
Density in foreground
scan
Check to enable the option.
DP data invalidate time-
out
This is a configurable time period after which the sys-
tem will set the density profile related entities to invalid
* Refer to TABLE 3-1 for additional information.
Properties Description
Vapour temp & pressure
enabled
Check to enable vapour pressure scan.
Pressure Type:
Absolute pressure Select if applicable.
Relative pressure Select if applicable.
Pressure address Enter vapour pressure transmission address.
Pressure TOI Select: B, C, E, or M*.
Pressure TOR Select: ZP3*.
Vapour Pressure in fore-
ground
scan
Check to enable the Pressure in foreground
scan.
* Refer to TABLE 3-1 for additional information.
Properties Description