Honeywell CIU 888 - Page 102

Getting Started
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 3 - 72
$*6
11.Click the Vapour Temperature tab, the Properties detail appears.
You can view or edit these properties:
12.Click the Product Pressure tab, the Properties detail appears
You can view or edit these properties:
Properties Description
Vapour temp. & pressure
enabled
Check to enable Vapour temp. & pressure scan
Vapour temp. address Enter vapour pressure transmission address.
Vapour temp. TOI Select the Type of Instrument: B, C, E, or M*.
Vapour temp. TOR Select the Type of Record for the Vapour Temperature
measurement: C or ZAG*.
Vapour temp. in
foreground scan
Check to enable the Vapour temp. in
foreground scan.
* Refer to TABLE 3-1 for additional information.
Properties Description
Product pressure
enabled
Check to enable product pressure scan.
Product Pressure Type:
Absolute pressure Select if applicable.