Calibration
4-18 SVP Controller Operation Manual Part No.: 44200004 - Revision 2
Gravimetric Water Draw Data Sheet
Date:
Prover Serial Number:
Prover Model Number:
Report Number:
Location:
Standard Temperature (Tb):
Standard Pressure (Pb)
Elevation (h)
Field Test Weight Density
Reference Test Weight Density
Compressibility Factor (water) (CPL):
Flow Tube Area Thermal Expansion Coefficient (Ga):
Detector Linear Thermal Expansion Coefficient (Gl):
Modulus of Elasticity of flow tube (E):
Flow Tube Inside Diameter (inches) (ID):
Flow Tube Wall Thickness (inches) (WT):
Fill 1 Fill 2 Fill 3 Fill 4 Fill 5
Fill Time (minutes) =
Temperature Air (Ta) =
Temperature Prover (Tp) =
Temperature Detector (Td) =
Prover Pressure (Pp) =
Water Electrical Conductivity =
Total Mass of Water (Ww) =
Density of Air ( ρA) =
Calculated Density of Water ( ρw) =
Correction of Air Buoyancy of Weighing (CBW) =
Corrected Mass of Water (Mw) =
Volume of Water (Vw) =
Effect of Pressure on Water (CPL) =
Temperature Correction on Prover (CTS) =
Pressure Correction on Prover (CPS) =
Corrected Water Volume (WD) =
Table 2: Gravimetric Water Draw Data Sheet
To Next Page
Loading...
Need help?
General
