Honeywell Farenhyt IFP-75HV - Page 68

68 IFP-75 Series Manual — P/N LS10147-001SK-E:E 4/6/2022
Programming Overview Mapping Overview
Emergency
Advisory
Trouble SBUS Expander Trouble General Trouble
Status Point Active SBUS Class A Trouble Site Silenced
SLC Loop Trouble
AC Loss Trouble F1 Key Active
Battery Trouble F2 Key Active
Ground Fault Trouble F3 Key Active
Phone Line Trouble F4 Key Active
Reporting Account Trouble
1 Temporal 4 coding cannot not be used for NAC circuits on CO Supervisory events.
System Zone Panel Site
Table 7.2 Event Types
Zone 1:
manual pull alarm
pattern 00
constant
pattern 02
ANSI 3.41
This example shows Zone 1 manual pull alarm event mapped to:
• Group 1 using constant output.
• Group 5 using ANSI 3.41 output pattern.
group 1
group 2
group 3
group 4
group 5
group 6
through
group 125
Figure 7.4 Example of Zone Events Mapped to Output Groups and Patterns
Zone 3
Offices
3rd floor
Zone 2
Storage
2nd floor
Zone 1
Show Room
1st floor
Group 3
3rd floor
notification
Group 2
2nd floor
notification
Group 1
1st floor
notification
supervisory
detector alarm
manual pull
constant
ANSI 3.41
ANSI 3.41
Zone 3
Offices
3rd floor
Zone 2
Storage
2nd floor
Zone 1
Show Room
1st floor
Group 3
3rd floor
notification
Group 2
2nd floor
notification
Group 1
1st floor
notification
supervisory
detector alarm
manual pull
constant
ANSI 3.41
ANSI 3.41
same floor
floor above
floor below
Figure 7.5 Example of Zone Events Mapped to Output Groups and Patterns