www.honeywell.com/security
52 | Performance Series IP Camera User Guide
Configuring 802.1X Settings
You can configure 802.1X settings on the Setup > Network > 802.1x page.
802.1X is a port-based network access control protocol for preventing unauthorized devices
from accessing the LAN. You can set up user name and password credentials for the camera
so that it is not blocked by the network switch.
To enable 802.1X:
1. Select the Enable check box.
2. In the
Username
field, enter the user name that will be used to authenticate the camera.
3. In the Password field, enter the password that will be used to authenticate the camera.
4. Click Save to apply the settings.
Configuring QoS Settings
You can configure Quality of Service (QoS) settings on the Setup > Network > QoS page.
QoS settings control bandwidth use by prioritizing certain data packets over others.
To enable QoS:
1. In the Realtime Monitor field, enter a DSCP (Differentiated Services Codepoint) value
for live video packets. Select a value between 0 (lowest priority) and 63 (highest priority).
2. In the Command field, enter a DSCP (Differentiated Services Codepoint) value for
non-video packets. Select a value between 0 (lowest priority) and 63 (highest priority).
3. Click Save to apply the settings.
To Next Page
Loading...
Need help?
General
