www.honeywell.com/security
64 | Performance Series IP Camera User Guide
Configuring Camera Tampering Events
You can configure camera tampering event settings on the Setup > Event > Video Detection
> Video Tampering page.
To enable camera tampering detection:
1. Select the Enable Video Tampering and/or the Enable Defocus Detection check
box(es).
2. Next to Working Period, click Setup. The Working Period window opens.
3. Set the days and times when you want the alarm function to be active, then click Save.
4. To start recording video when a tampering event is detected, ensure that the Record
check box is selected.
5. In the Record Delay field, enter the number of seconds that the system will continue to
record video after a tampering event has ended. Enter a value between 10 and 300.
6. To send an email notification when a tampering event is detected, select the Send
Email check box. Email settings must be configured in Setup > Network > SMTP
(Email). See Configuring Email Settings on page 49.
To Next Page
Loading...
