Configuring Network Settings | 43
800-23288 - A - 07/2017
4. Open the Command Prompt window on your PC (in Windows 7, click Start > All
Programs > Accessories > Command Prompt) and type the appropriate commands for
your operating system:
5. Reboot the camera. If the setup was successful, the Command Prompt window will
display “Reply from" and the IP address (for example, "Reply from 192.168.0.125 …”).
To verify that the IP address works, open your browser and type in the address bar
http:// followed by the IP address (for example, http://192.168.0.125), then press
Enter.
Configuring Easy4ip
You can configure peer-to-peer settings (for connecting remotely via the HonView Touch
app) on the Setup > Network > TCP/IP > Easy4ip page.
To Next Page
Loading...
