Configuring Recording Settings | 57
800-23288 - A - 07/2017
Configuring Storage Paths
On the Path tab, you can specify where you want recorded video and snapshots—whether
scheduled or triggered by a motion detection or alarm event—to be saved: to a local SD card,
to an FTP server, or to an NAS disk.
Select which recorded events you want to save and where you want to save them, then click
Save to apply the settings.
Note Only one network storage option can be used at a time. FTP and NAS cannot
be used together.
Configuring the Local SD Card for Storage
If the camera has a microSD card installed, the Local tab displays the microSD card details.
You can set up the installed microSD card for read-only, read-and-write, or hot swap
operation by clicking the corresponding button.
• Read Only: Data on card can be displayed but not modified.
• Read & Write: Data on card can be displayed and modified.
• Hot Swap: Card can be inserted or removed without turning off the camera.
If you want to erase all of the data on the microSD card, click Format. A confirmation
message appears. Click OK to continue. The card is formatted and the camera reboots.
To Next Page
Loading...
Need help?
General
