www.honeywell.com/security
68 | Performance Series IP Camera User Guide
To enable network event detection:
1. On the Network tab, select the event type that you want to configure from the Event
Type list (Disconnection or IP Conflict).
2. Select the Enable check box.
3. To start recording video when the event is detected, select the Record check box.
4. In the Record Delay field, enter the number of seconds that the system will continue to
record video after the event has ended. Enter a value between 10 and 300.
5. Click Save to apply the settings.
Configuring Illegal Access Event Settings
An illegal access event occurs when a specified number of unsuccessful login attempts is
exceeded.
To enable illegal access detection:
1. On the Illegal Access tab, select the Enable check box.
2. In the Login Error field, enter the number of unsuccessful login attempts the system
will allow before an illegal access event is detected. Enter a value between 3 and 10.
3. To send an email notification when an illegal access event is detected, select the Send
Email check box. Email settings must be configured in Setup > Network > SMTP
(Email), See Configuring Email Settings on page 49.
To Next Page
Loading...
