ii
Cautions and Warnings
WARNING Installation and servicing should be performed only by qualified
and experienced technicians to conform to all local codes and to maintain your
warranty.
WARNING To ensure compliance with electrical safety standards this
product is intended for use with a Listed Power Adapter marked with “Limited
Power Source”, “LPS”, on the unit, output rated 12 V DC, minimum 0.7A, Tma=60°C
or from Power over Ethernet (PoE) provided by Listed Information Technology
Equipment meeting the IEEE 802.3af PoE standard.
The Ethernet connection is not intended to be connected to exposed (outside
plant) networks. Do not connect two power sources to the camera at the same time.
CAUTION Invisible LED radiation (850 nm). Avoid exposure to beam.
Regulatory Statements
FCC Compliance Statement
Information to the User: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
