Performance Series IP Camera Software Configuration Guide
38
Table 6-3 SMTP (Email) Configurations
Parameter Function
SMTP Server Enter the server address.
Port
The default setting is 25. You can modify this setting as
necessary.
Anonymous
Supports the anonymity function for the server. You can
automatically log in anonymously. You do not need to enter the
user name, password, and the sender information.
User Name Enter the username for the sender’s email
Password Enter the password for the sender’s email
Sender Enter the sender’s email address.
Authentication This is the encryption mode. Select SSL, TLS, or None.
Title Enter the email subject.
Attachment
Select the check box to have the system send out a snapshot
with the email.
Mail Receiver
Enter the receiver’s email address here. You can enter up to
three addresses.
Send Health
Messages
To have the system periodically verify that the email notification
settings are working, select the Send Health Messages check
box, and specify the Interval.
Interval
The interval for sending ranges from 0 to 3600 seconds. 0
seconds means that there is no interval.
The system will not immediately send the email when the alarm
occurs. When an alarm, motion detection, or other event occurs
to activate an email, the system sends the email according to
the interval that you have specified here. This reduces the load
on the email server when multiple emails are triggered
simultaneously.
Email Test
The system will automatically send an email to test the
connection.
Before you can do an email test, you must save the email setup
information.
Configuring UPnP Settings
Go to Setup Network Setup UPnP.
UPnP lets you establish the mapping relationship between the LAN and the public network. In
the UPnP configuration interface, you can add, modify, or remove a UPnP item.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
