Performance Series IP Camera Software Configuration Guide
52
Threshold
Drag the slider to adjust the threshold value. The default value is 50. If
the environmental noise is too big, then the value needs to be set higher.
You need to adjust it according to the actual environment test.
Alarm
Period
The audio detection function is activated during the specified period.
See Configuring the Alarm Period on page 47.
You can configure up to six periods per day. Select a date. If you do not
select a date, the current setup will be applied to today only. You can select
All to apply the alarm period to the whole week.
Click OK to save the changes. The system goes back to the scene
change interface. Click Save to exit.
Anti-Dither
Enter the anti-dither time in seconds. Enter a value between 0 and 100
seconds. The system will only allow one motion detection event within this
period.
Record If Record is enabled, an audio detection event can activate recording.
Record
Delay
The system will wait for the specified time before it begins recording. Select
from 10s to 300s.
Send Email When enabled, the system sends an email alert when an alarm occurs.
Snapshot
When enabled, the system attaches a snapshot to an email alert when an
alarm occurs.
Configuring Smart Plan
Smart plan is a master switch for the intelligent analytics such as Face Detection and People
Counting. The device intelligent functions can be valid after smart plan is enabled.
Go to Setup Video Analytics Smart Plan. Select the plan by clicking its icon and click
Save.
Figure 7-7 Smart Plan
To Next Page
Loading...
Need help?
General
Weight and Dimensions
