Performance Series IP Camera Software Configuration Guide
78
Table 11-1 Alarm Configurations
Type Parameter Function
Alarm Type
Motion Detection
Check to enable Motion Detection. The system will then trigger an
alarm when motion is detected under the specified circumstances.
Disk Full
Check to enable Disk Full. The system will then trigger an alarm when
the disk (microSD card) is full.
Note This function is not supported by the following models:
HPW2P1/HBW2PER1.
Video Tampering
Check to enable Video Tampering. The system will then trigger an
alarm when the camera has been tampered with.
Disk Error
Check to enable Disk Error. The system will then record alarm
information when a microSD card error occurs.
Note This function is not supported by the following models:
HPW2P1/HBW2PER1.
Illegal Access
Check to enable Illegal Access. The system will then trigger an alarm
when someone attempts to illegally access the camera.
Scene Change
Check to enable Scene Change. The system will then trigger an
alarm when the camera scene change event occurs.
Operation Prompt
Check to enable Prompt. The system will then automatically pop up an
alarm message on the main window when there is an alarm.
Alarm Sound
Play Alarm Sound
Check to enable Play Alarm Sound. When an alarm occurs, the system
automatically generates an audible sound. You can select a sound from
your PC for the alarm sound prompt.
Alarm Sound Path Select the alarm sound file.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
