84
Honeywell 30 Series IP Cameras User Guide
Figure 97 Access List
General Settings
Concurrent user number: Simultaneous live viewing for 1~10 clients (including main
stream to third stream). The default value is 10.
Filter
Enable access list filtering: Check this item and click SAVE to enable the access list
filtering function.
Filter type: Select Allow or Deny as the filter type.
• If you choose Allow, only those clients whose IP addresses are on the Access List
below can access the camera, and the others cannot.
• If you choose Deny, those clients whose IP addresses are on the Access List below
will not be allowed to access the camera, and the others can.
Click ADD and you can add a rule to the following Access List.
Single: This rule allows the user to add an IP address to the Allowed/Denied List.
Network: This rule allows the user to assign a network address and corresponding
subnet mask to the Allow/Deny List. The address and network mask are written in CIDR
format.
Range: This rule allows the user to assign a range of IP addresses to the Allow/Deny
List.
Note:
The IPv6 access list column will not be displayed unless you enable IPv6 on the
Network page. For more information about IPv6 settings, see
Enable IPv6
on page
43
.
The Range rule only applies to IPv4 addresses.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
