Honeywell HD251(X) - Camera Title

20 | HD251(X)/HD262(X)/HB273(X) Camera Configuration Guide
www.honeywellvideo.com
Camera Title
When enabled, the Camera Title may be entered and displayed on the video monitor.
1. Move the arrow indicator to CAMERA TITLE using the Up or Down OSD controls
on the SPECIAL menu screen.
2. Set to ON using the Left or Right OSD controls.
3. Press SET.
The Camera Title can be up to 15 alphanumeric characters in length.
Figure 21 Setting the CAMERA TITLE
4. Move the cursor to select an alphanumeric character.
Choose a character from the displayed range of A to Z, and 0 to 9 using the Up,
Down, Left and Right OSD controls.
5. Enter the selected character into the camera title by pressing SET.
The cursor in the camera title moves to the next position after each character is
input, by pressing SET.
6. Repeat the above steps until the camera title is complete.
Note If an incorrect character has been input into the camera title, you have
two options for correcting the camera title:
• Move the cursor to select CLR and press SET to delete the entire
camera title. Enter another camera title, as needed.
• Move the cursor to select either  or  and press SET to change the
position of the cursor in the current camera title. Continue to press
SET on either  or  until the cursor is highlighting a character in
the camera title that you want to change. The selected character is
CAMERA TITLE
ABCDEFGHIJKLMNOP
QRSTUVWXYZ012345
6789 !"#$%&’()*+
,-./<=>?@[\]^_
  CLR POS RET
CAMERA001______