28 | HD251(X)/HD262(X)/HB273(X) Camera Configuration Guide
www.honeywellvideo.com
Monitor
The Monitor setting is used to specify the type of monitor you are using, and adjust the
video signal so it can be optimally displayed on that monitor.
1. Select MONITOR in the ADJUST menu by using the Up and Down OSD controls.
2. Change the MONITOR selection by using the Left and Right OSD controls (see
Figure 31). Monitor options are:
• LCD: Select this option when you are using an LCD monitor with the camera.
• CRT: Select this option when you are using an CRT monitor with the camera.
Gamma
Use the Gamma setting to adjust the gamma correction value. Gamma can be adjusted
from between 0.20 and 1.00.
LSC
The LSC function is used for compensating the brightness differences of the center of the
lens and its peripheries. When set to ON, LSC can be adjusted from 0 to 30.
1. Select LSC in the ADJUST menu by using the Up and Down OSD controls.
2. Change the LSC selection by using the Left and Right OSD controls.
3. Set LSC to ON and press SET to open the LSC menu (see Figure 32).
4. Change the LSC set level, as needed, from 0 to 30.
5. Select RETURN and press SET.
Figure 32 ADJUST Menu - LSC Submenu Selection
ADJUST
SHARPNESS
15
MONITOR LCD
GAMMA 0.55
LSC ON
LANGUAGE ENGLISH
COMMUNICATION
OFF
DEFECT AUTO
RETURN
LSC
SET LEVEL
10
RETURN
To Next Page
Loading...
