Configuring the Camera | 29
800-12004V2 - A - 01/2013
Language
The Language option is used to change the language of the OSD menus.
1. Select LANGUAGE in the ADJUST menu by using the Up and Down OSD controls.
1. Change the LANGUAGE selection by using the Left and Right OSD controls (see
Figure 31). You can select the language from: English, Russian, Spanish, Italian,
French, Turkish, Chinese 1 and 2, Korean, and Japanese.
Communication
This feature is not currently supported.
Defect
When set to AUTO, the AUTO DEFECT function corrects image errors caused by defective
pixels in real time while SENS-UP occurs.
1. Select DEFECT in the ADJUST menu by using the Up and Down OSD controls.
2. Change the DEFECT selection by using the Left and Right OSD controls.
3. Set DEFECT to AUTO and press SET to open the DEFECT menu (see Figure 33).
Figure 33 ADJUST Menu - DEFECT Submenu Selection
4. Change the WHITE THR and LUMA THR values, as needed, to increase or
decrease the amount of defects that are corrected.
5. Select RETURN and press SET.
ADJUST
SHARPNESS
15
MONITOR LCD
GAMMA 0.55
LSC ON
LANGUAGE ENGLISH
COMMUNICATION
OFF
DEFECT AUTO
RETURN
DPC AUTO
WHITE THR
15
LUMA THR
30
RETURN
To Next Page
Loading...
