A - 2
Note: “m” represents the AIM modifier character. Refer to International
Technical Specification, Symbology Identifiers, for AIM modifier character
details.
Prefix/Suffix entries for specific symbologies override the universal (All
Symbologies, 99) entry.
ASCII Conversion Chart (Code Page 1252
)
Note: This table applies to U.S. style keyboards. Certain characters may differ
depending on your Country Code/PC regional settings.
UPC-E ]E0 E (0x45)
UPC-E with Add-On ]E3 E (0x45)
UPC-E1 (obsolete) ]X0 E (0x45)
Non-Printable Characters
DEC HEX Character (Code) DEC HEX Character (Code)
0 0 NULL 16 10 DATA LINK ESCAPE (DLE)
1 1 START OF HEADING
(SOH)
17 11 DEVICE CONTROL 1 (DC1)
2 2 START OF TEXT (STX) 18 12 DEVICE CONTROL 2 (DC2)
3 3 END OF TEXT (ETX) 19 13 DEVICE CONTROL 3 (DC3)
4 4 END OF TRANSMISSION
(EOT)
20 14 DEVICE CONTROL 4 (DC4)
5 5 END OF QUERY (ENQ) 21 15 NEGATIVE ACKNOWLEDGE-
MENT (NAK)
6 6 ACKNOWLEDGE (ACK) 22 16 SYNCHRONIZE (SYN)
7 7 BEEP (BEL) 23 17 END OF TRANSMISSION
BLOCK (ETB)
8 8 BACKSPACE (BS) 24 18 CANCEL (CAN)
9 9 HORIZONTAL TAB (HT) 25 19 END OF MEDIUM (EM)
10 A LINE FEED (LF) 26 1A SUBSTITUTE (SUB)
11 B VERTICAL TAB (VT) 27 1B ESCAPE (ESC)
12 C FF (FORM FEED) 28 1C FILE SEPARATOR (FS)
RIGHT ARROW
13 D CR (CARRIAGE RETURN) 29 1D GROUP SEPARATOR (GS)
LEFT ARROW
14 E SO (SHIFT OUT) 30 1E RECORD SEPARATOR (RS)
UP ARROW
Symbology AIM ID
Possible AIM
ID Modifiers
(
m
)
Code ID
(hex)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
