Honeywell Hyperion 1300G

iii
Output Sequence Overview ...................................... 3-10
To Add an Output Sequence............................... 3-10
Other Programming Selections ........................... 3-11
Output Sequence Editor...................................... 3-11
Require Output Sequence................................... 3-11
Output Sequence Editor...................................... 3-13
Require Output Sequence................................... 3-13
Multiple Symbols ....................................................... 3-14
No Read .................................................................... 3-15
Video Reverse........................................................... 3-15
Chapter 4 - Data Editing
Prefix/Suffix Overview ................................................. 4-1
To Add a Prefix or Suffix ....................................... 4-1
To Clear One or All Prefixes or Suffixes................ 4-2
To Add a Carriage Return Suffix to All
Symbologies.......................................................... 4-3
Prefix Selections.................................................... 4-3
Suffix Selections.................................................... 4-4
Function Code Transmit........................................ 4-6
Intercharacter, Interfunction, and Intermessage
Delays ......................................................................... 4-6
Intercharacter Delay.............................................. 4-7
User Specified Intercharacter Delay...................... 4-7
Interfunction Delay ................................................ 4-8
Intermessage Delay .............................................. 4-8
Chapter 5 - Data Formatting
Data Format Editor Introduction .................................. 5-1
To Add a Data Format........................................... 5-1
Other Programming Selections ............................. 5-2
Interface / Terminal ID Table....................................... 5-4