Honeywell Hyperion 1300G

vii
Chapter 9 - Serial Programming Commands
Conventions ................................................................ 9-1
Menu Command Syntax.............................................. 9-1
Query Commands ................................................. 9-2
Concatenation of Multiple Commands .................. 9-2
Responses ............................................................ 9-2
Examples of Query Commands ............................ 9-3
Trigger Commands ..................................................... 9-4
Resetting the Standard Product Defaults.................... 9-4
Menu Commands........................................................ 9-5
Chapter 10 - Product Specifications
Hyperion 1300g Product Specifications .................... 10-1
Standard Connector Pinouts ..................................... 10-2
Chapter 11 - Maintenance
Repairs...................................................................... 11-1
Maintenance.............................................................. 11-1
Cleaning the Device ............................................ 11-1
Inspecting Cords and Connectors....................... 11-1
Replacing the Interface Cable............................. 11-2
Troubleshooting ........................................................ 11-2
Chapter 12 - Customer Support
Product Service and Repair ...................................... 12-1
Limited Warranty ....................................................... 12-1
Appendix A
Symbology Chart.........................................................A-1
ASCII Conversion Chart (Code Page 1252) ...............A-2
Code Page Mapping of Printed Bar Codes .................A-5