Introduction
Page 36 34-ST-25-20 MC Toolkit User Manual Release 3
9/06
MC Toolkit Software with Honeywell HART Transmitters
Introduction
This section contains procedures for using the MC Toolkit application software to communicate with
Honeywell and non-Honeywell Transmitters with HART communications protocol. In some cases, the
Honeywell transmitters differ somewhat from non-Honeywell transmitters, separate procedures are
provided as appropriate. It is recommended that you use SDC 625 application software when
communicating with non-Honeywell devices. For specific data relating to parameters involved in the
procedures, refer to
Reference Data.
Figure 10 Menu Tree - Honeywell HART Displays
To Next Page
Loading...