134
www.honeywell.com
Page 134
Mini-AT User Guide
Item
No. Item Name Description
————————————————————————————————————————
412 PLOG TRANSDUCER RGE The upper range limit of the PLog pressure transducer, always
expressed in PSI.
Default = 100.00
413 PLOG REF PRESS #1The PLog pressure value used during the most recent PLog
ZERO calibration.
Default = 0.00
414 PLOG CAL ZERO The most recent offset value for the PLog pressure transducer,
obtained during a PLog Zero calibration. The value is
normally very close to 0.0000 and is recalculated during each
PLog Pressure Zero calibration.
Default = 0.0000
415 1 PREV PLOG CAL ZERO The previous value of item 414, updated on each PLog
Pressure Zero Calibration.
Default = 0.0000
416 PLOG REF PRESS #2The PLog pressure value used during the most recent PLog
SPAN calibration.
Default = 0.00
417 PLOG CAL SPAN The most recent span value for the PLog pressure transducer
obtained during a PLog Span calibration. The value is
normally very close to 1.0000 and is recalculated during each
PLog Pressure Span Calibration.
Default = 1.0000
418 1 PREV PLOG CAL SPAN The previous value of item 417, updated on each PLog
Pressure Span Calibration.
Default = 1.0000
419 PLOG XDCR RANGE The upper PLog pressure limit, automatically scaled to the
pressure units selected at item 408. If PSI is the selected
pressure units, then item 419 will be the same as item 412.
Note; the value at item 419 may be manually edited to a
rounded-off number, if desired.
Default = 100.00
420 PLOG GAS PRESSURE PLog gas pressure measured at the last wake-up. The pressure
value is scaled to the unit of pressure measurement selected at
item 408 and displayed with the appropriate number of
decimal positions as selected at item 420.
To Next Page
Loading...
Need help?
General
