MORLEY-IAS Dimension Series
Page 10 Document No. 996-148-000-5, Revision: 5 User Manual
• Press the ‘F1’ key again to toggle to the next highest priority event category available. Where no
category is available, the display will revert to the original summary/zone display.
• Press ’X’ or any numeric key when viewing the active events and the display will revert to the
summary display.
3.3.2.3 Panel Status Summary
• If the panel is in a fire and/or a fault and/or a test and/or a disablement condition the display shows the
status of the panel as follows:
<FIRES> :1 FAULTS :1 ←R→:Select
DISABLED :0 IN TEST :0 9:Details
• The display shows the number of fire alarms, faults, disablements and zones in test. The above
example shows that there is one fire alarm and one fault condition present.
EN54
9
EN54-2 5.1
Viewing
Suppressed
Information.
• All of the mandatory indications that may not be suppressed during a
fire alarm condition are shown using Light Emitting (LED) Indicators.
Fire Alarms are shown using LED Indicators for each zone.
• It is possible to view all other conditions such as points in fire, faults,
zones in test and disablement conditions using the arrow keys at
Level 1.
• To view the information for a particular condition, use the ÍÏÐÎ keys to select the required
condition (the ‘<’ and ‘>’ brackets move to the selected option and flash) and then press the
9 key to
select and view further detail.
3.3.3 Level 2 Menu Displays
• When the Level 2 Menu Displays are selected, the display shows a number of listed options. The
example below shows the main Level 2 Menu options. All other menus are similar.
[U0] 1:Commission 2:Test 3:Clock
4:Disable/Enable 5:View Mode
To Next Page
Loading...
