Dimension Series MORLEY-IAS
User Manual Document No.996-148-000-5, Revision: 5 Page 13
• To view other points in fire in this zone, press the Ï and Ð keys (Note: The ‘R: more’ option is not
shown if there is only one event, the ‘↓’ and ‘↑’ keys are shown for the first and last entries in the list).
• To return to the list of zones in fire, press the Í key.
4.2.1.3 Override Delays
EN54
EN54-2 7.11d
Override delays at
Level 1
• The DX1e, DX2e and DX4e control panels can be
configured to operate with delays to outputs. In this
case, a manual call point (MCP) will be located next
to the panel.
• To override any delays and immediately activate the
bells and other fire alarm output devices, break the
glass in the call point.
BREAK GLASS
Press Here
FIRE
4.2.2 Fault Conditions
• If the panel detects a fault, the FAULT LED is illuminated along with other appropriate system
condition LED Indicators. The internal buzzer will sound and the alphanumeric display will indicate the
number of faults.
• To view more detailed information regarding the fault locations use the navigation keys as follows.
• Press the ÍÏÐÎ keys to select the FAULT option and then press the
9 key. The display shows
further information on the faults. For example:
TOTAL PANEL FAULTS :3 →:Panel Events
TOTAL ZONES IN FAULT :1 ↓:Zone Details
• This display indicates that there is one zone in fault and that three panel related faults have been
registered. To view these, press the Î key to view the panel related faults and press the Ð key to
view the zones in fault.
4.2.2.1 Panel Faults
FAULT 02/03 MON INPUT 1 12:15
INPUT OPEN CIRCUIT ←:back R:more
• The above example shows there are three panel related faults and fault number two is shown. This
was an input open circuit on “Monitored Input 1” registered at 12:15PM.
• If there is more than one fault indicated, use the Ï and Ð keys to view these (Note: The ‘R: more’
option is not shown if there is only one event, the ‘↓’ and ‘↑’ keys are shown for the first and last entries
in the list). Press the Í key to return to the main display.
4.2.2.2 Zone Faults
• When selected, the display shows the first zone with a fault condition. For example:
IN FAULT ZONE 1 01/01 R: More Zones
<Zone-Location-Text> →:Device Details
• The display shows the Zone number and Zone Location Text (20 character description).
To Next Page
Loading...
