22 NFS2-3030 Programming Manual — P/N 52545:K1 03/20/2012
Program Panel Program
DISPLAY ADDR
ESS: Press this soft key to toggle between YES and NO. Choose YES to display
all point address information at the top of event screens and in printouts. Choose NO to suppress
address information display and printing. Default: YES
REMINDER MENU:
Press this soft key to bring up the Reminder Menu screen.
ACCEPT: Press this
soft key to save the information entered on this screen.
MORE: Press this
key to progress to the second Panel Settings screen.
Figure 3.7 Panel Settings (2) Screen
Soft Keys
LCM LOCAL MO
DE: Press this soft key to toggle between YES and NO. Enter YES to enable all
SLCs to participate in local mode. When enabled, all LCMs will operate together in a limited
fashion when communication is lost with the NFS2-3030 CPU. Inputs on LCM loops (and
associated LEM loops, if installed) will activate outputs on all loops
• for those inputs and outputs that have been set with point programming to participate in local
mode, an
d
• when type codes are the same point type: that is, an input with
a fire type code will activate an
output with a fire type code. (Refer to Appendix G, “Type Codes”, on page 138 for point types).
Default: NO
POWER MANAGEMENT MOD
E: Select ON to invoke the power management mode to conserve
power consumption. In this mode, the number of LEDs that can be turned ON on a particular loop
will be limited. A maximum of 30 input device (monitor modules and detectors) LEDs will be
allowed ON at a time. No output module LEDs will turn ON. When the limit of 30 LEDs is
reached, every time a new LED is turned ON, the oldest LED activation will turn OFF and will poll
in red rather than the usual green. Default:OFF
USA Event Order Canada Event Order
Fire Fire
Security Supervisory
Supervisory Trouble
Trouble Prealarm
Prealarm Disabled
Disabled
Table 3.1 Event Ordering
PANEL SETTINGS
LCM LOCAL MODE: YES REGIONAL SETTINGS
POWER MANAGEMENT MODE:OFF
DCC PARTICIPATION: NO MORE
RAPID ALL CALL: NO ACCEPT
DEFAULT SETTINGS BACK
To Next Page
Loading...
Need help?
General
