NFS2-3030 Programming Manual — P/N 52545:K1 03/20/2012 23
Panel Program Program
DCC PARTICIPATION: Press this key to program the panel for DCC (Display and Control Center)
participation. This network function ensures that one location at a time is in command of the
Acknowledge, System Reset, Signal Silence and Drill functions. Default: NO
RAPID ALL C
ALL: Set YES to invoke Rapid All Call for XP Series transponder modules. For use
when retrofitting an AM-2020/AFP-1010 system that has XPP modules used for audio operation.
This setting causes these modules to activate more quickly. Rapid All Call is used with the
“Speaker” type code. Default:NO
DEFAULT SETT
INGS: Press this soft key to activate default settings for the following:
REGIONAL SETTI
NGS: Press this soft key to proceed to the Regional Settings screen. Press the
soft key to scroll through the selections. The default is that there are no special regional settings.
Other settings are explained in Appendix I, “Regional Settings”.
MORE: Press this
key to progress to the third Panel Settings screen.
Figure 3.8 Panel Settings (3) Screen
CAUTION:
ON SYSTEMS UTILIZING THE DCC FUNCTION, ALL LOCATIONS THAT CAN PARTICIPATE IN
DCC SHOULD BE SET TO YES.
Program Setting for: Default:
Local Control YES
Piezo ON
Proprietary Supervising Station NO
Event Ordering USA
Display Address YES
LCM Local Mode NO
DCC Participation NO
Power Management OFF
Rapid All Call NO
Table 3.2 Default Settings
PANEL SETTINGS
SOUNDER BASE SETUP MORE
NETWORK DISPLAY MODE:ON ACCEPT
DRILL MODE:CUSTOM
BACK
To Next Page
Loading...
Need help?
General
