Honeywell SLC - Section 10 Addressable Beam Detectors; 10.1 Beam Detector Description; 10.2 Beam Detector Installation and Wiring; 10.2.1 Setting Beam Detector SLC Address

FireLite SLC Wiring Manual — P/N 51309:P4 9/17/2014 65
Section 10: Addressable Beam Detectors
10.1 Description
The BEAM355 and BEAM355S are intelligent, addressable projected beam smoke detectors,
designed for protecting open areas with high and sloping ceilings and wide-open areas, where spot
type smoke detectors are difficult to install and maintain. The BEAM355S has an integral sensitiv-
ity test feature that consists of a test filter attached to a servomotor inside the detector optics.
10.2 Installation and Wiring
10.2.1 Setting an SLC Address for a Beam Detector
Each beam detector is factory preset with an address of “00.” To set an SLC address, use a com-
mon screwdriver to adjust the address rotary code switches on the detector to the desired address
(refer to 5.2.1“Setting an SLC address for a Single Point Module” on page 34).
NOTE: This section provides basic wiring and addressing information. For critical information
on device installation, operation and alignment, refer to the Installation Instructions provided with
these devices.