Honeywell SLC - 10.2.2 Wiring a Beam Detector

66 FireLite SLC Wiring Manual — P/N 51309:P4 9/17/2014
Addressable Beam Detectors Installation and Wiring
10.2.2 Wiring a Beam Detector
Typical wiring of a beam detector connected to an SLC is illustrated in the figure below.
Figure 10.1 Beam Detector Terminal Block Wiring
SLC (-) to next device
SLC (+) to next device
SLC (-) from panel or previous device
SLC (+) from panel or previous device
Test Option (-)
Test Option (+)
not used
not used
Reset Input
Test Input
Remote Alarm Out
Aux (-)
Alignment Switch
Sensitivity Switch
Test Switch
Reset Switch
Style 7 Isolator Shunts
RTS151/KEY& RTS-451/KEY
Connections
Digital Signal
Strength Readout
ONES TENS
ADDRESSING
CODE
SWITCHES
Alignment Mirror
Alignment Position
Indicator
Optics Lock-down
Screws
Alignment Gunsight
Horizontal Adjustment
Vertical Adjustment