Honeywell SMV800 - 2.3.6. Meterbody Temperature Config

Page 28 SMV800 Modbus User's Guide Revision 1.0
2.3.6. Meterbody Temperature Config:
This tab provides the detail information about the Meterbody Temperature parameters.
Refer the below table for Meterbody Temperature Configuration:
Meter Body Temperature Configuration parameters
Key: Plain = Read only Bold = Configurable Bold underline = Method Bold italic = Table or graph
Meter body Temp. Config
Meter Body Temperature
The current value of the measured Meter body
Temperature
Meter Body Temperature Unit
degC
degF
degR
Kelvin
The engineering unit for the Meter body
Temperature value
Meter Body Temperature LRV
The Lower Range Value for the Meter body
Temperature input
Meter Body Temperature
URV
The Upper Range Value for the Meter body
Temperature input
Meter Body Temperature
Damping
Damping value for the Meter body
Temperature measurement. Entries may be
any value from 0.00 to 32.00 seconds.
Meter Body Temperature URL
The Upper Range Limit for the Meter body
Temperature value
Meter Body Temperature LRL
The Lower Range Limit for the Meter body
Temperature value