Honeywell SMV800 - 2.3.7. Process Temperature Configuration

Revision 1.0 SMV800 Modbus User's Guide Page 29
2.3.7. Process Temperature Configuration
This tab provides the detail information about the ProcessTemperature parameters.
Refer the below table for Process Temperature Configuration:
Process Temperature Configuration parameters
Key: Plain = Read only Bold = Configurable Bold underline = Method Bold italic = Table or graph
Process Temp.Config
Process Temperature
The current value of the Process
Temperature input
Process Temperature Unit
● degC
● degF
● degR
● Kelvin
The user selected engineering unit for
the Process Temperature input.
Process Temperature LRV
The Lower Range Value for the
Process Temperature input (which
represents 0% output) in user selected
engineering units. This value may be
configured to any value within the range
PT LTL to PT UTL.
Process Temperature URV
The Upper Range Value for the
Process Temperature input (which
represents 100% output) in user
selected engineering units. This value
may be configured to any value within
the range PT LTL to PT UTL.
Process Temperature
Damping
Damping value for the Process
Temperature output. The upper limit for
temp damping is 102. Entries may be
any value from 0.00 to 32.00 seconds.
Process Temperature URL
The Upper Range Limit for the Process
Temperature input
Process Temperature LRL
The Lower Range Limit for the Process
Temperature input