Honeywell SMV800 - Page 49

Revision 1.0 SMV800 Modbus User's Guide Page 37
Configure Flow Setup parameters
Refer below table for more details regarding parameters.
Advanced Flow Setup Parameters
Key: Plain = Read only Bold = Configurable Bold underline = Method Bold italic = Table or graph
Fluid Type
Gas
Liquid
Superheated Steam
Saturated Steam (DP, SP)
Saturated Steam (DP, PT)
1,2,3 – applicable when:
Algorithm Options = Advanced
Algorithms or ASME 1989 Algorithms
4,5 – applicable when
Algorithm Options = Advanced
Algorithms
Flow Output Type
No Flow Output
Ideal Gas Actual Volume Flow
Ideal Gas Mass Flow
Ideal Gas Volume Flow @ Std Condition
When Fluid type = Gas
No Flow Output
Liquid Mass Flow
Liquid Actual Volume Flow
Liquid Volume Flow @ Std Condition
When Fluid type = Liquid
No Flow Output
Steam Mass Flow
When Fluid type =
Superheated Steam or
Saturated Steam (DP, SP) or
Saturated Steam (DP, PT)
Algorithm Options
Advanced Algorithms
ASME 1989 Algorithms
Advanced Algorithms: Allows Flow
calculation using newer Standards
using predefined list of Primary
Elements.
ASME 1989 Algorithms: Allows
selecting legacy SMV3000 algorithms
and Primary Elements
Equation Model
Dynamic
Standard
Dynamic option allowed on Advanced
Algorithms or ASME 1989 Algorithms
Algorithm. Select ASME 1989
Algorithm Option if you need to
calculate Standard Flow