Honeywell SMV800 - Page 59

Revision 1.0 SMV800 Modbus User's Guide Page 47
Density
Manual Input Density
ON/OFF
When Algorithm Option = Advanced
Algorithms
Fluid Type = Liquid
Density Coefficient_d#
#.#
When Algorithm Option = SMV3000 /ASME
1989 with Dynamic Corrections or Standard
Fluid Type = Liquid
Equation Model = Dynamic or Standard
Lower TempLimit Density
TpMin
Minimum Temperature to select the initial
Temperature vs Density value in the
polynomial equation for auto calculation of
Density. Enter the temperature value in the
selected unit in the Unit Configuration
screen.
Upper TempLimit Density
TpMax
Maximum Temperature to select the end
point Temperature vs Density value in the
polynomial equation for auto calculation of
Density. Enter the temperature value in the
selected unit in the Unit Configuration
screen.