Page 60 SMV800 Modbus User's Guide Revision 1.0
Totalizer
Allows configuration of Totalizer Ranges, Units and Modes.
Refer below tables for more details regarding parameters.
Totalizer Configuration parameters
Key: Plain = Read only Bold = Configurable Bold underline = Method Bold italic = Table or graph
This is the Totalized Flow as calculated
based on the flow rate during the time that
the Totalizer is in Run mode. The Totalizer
will increment during Forward (positive) flow
and decrement during Reverse (negative)
flow. Note: the Reverse Flow configuration
setting must be enabled to calculate
negative flow.
This is the Totalized Flow for Forward flow
only. The Positive Totalizer will increment
when the Flow Rate is a forward flow
(positive flow value).
This is the Totalized Flow for Reverse flow
only. The Negative Totalizer will decrement
when the Flow Rate is a reverse flow
(negative flow value). Note that the Reverse
Flow configuration setting must be enabled
to calculate negative flow.
To Next Page
Loading...
