How to fix Honeywell Control Systems screen that does not respond to user input?
If the Honeywell Control Systems screen isn't responding to user input as expected, the touch screen may require recalibration.
What to do if Honeywell Control Systems channel inhibit cannot be cleared?
If you cannot clear an inhibit from a Honeywell Control Systems channel, ensure all inhibit conditions are resolved, as multiple conditions may be active. Refer to detailed actions below for I/O channels.
What causes fluctuating input signal in Honeywell Control Systems?
A fluctuating input signal in Honeywell Control Systems can be caused by HART communication with the corresponding field device. This fluctuation should clear when HART communication ceases.
How to troubleshoot Honeywell Control Systems channel alarm malfunction?
If a Honeywell Control Systems channel or alarm isn't functioning as expected, check the definitions of parameters in Commissioning, Channel Configuration, and verify settings accordingly. Some parameters may be defined in a different way.
How to fix Honeywell Control Systems calibration signal too high error?
If you encounter a ‘Calibration Signal Too High’ error when calibrating the mA loop in Honeywell Control Systems, review the channel configuration. Under Calibration Settings, verify the 'Maximum Span Signal' value. If necessary, use a lower forced mA value to calibrate the channel.
What to do if Honeywell Control Systems module shows present after removal?
If a Honeywell Control Systems module still appears present and available for configuration after removal, follow the instructions to properly remove it from the system, see Maintenance, How to Remove or Decommission an I/O Module.
General| Category | Control Systems |
|---|---|
| Touchscreen | Yes |
| Power Supply | 24 VDC |
| Display Type | LCD |
| Connectivity | Ethernet |
| Communication | Modbus |
| Communication Ports | RS485, Ethernet |
| Operating Temperature | 0°C to 50°C |
| Mounting | Wall mount, Panel mount |
To Next Page
