TR50 - User Guide 15
DIP Switch (Address settings): The Auto MAC address for the BACnet mode is all
ON/OFF.
4.2.2 Modbus Mode
Slide Switch: The slide switch is set to LEFT to work in Modbus network mode.
DIP Switch (Protocol selection): The Modbus protocol switch is set to ON/OFF or
1/2 address.
DIP Switch (Address settings): The Modbus device address range is between 1 to
247 and it can be configured manually through the DIP Switch.
4.2.3 Slyk
TM
Bus
Mode
Slide Switch: The slide switch is set to RIGHT to work in Sylk
TM
Bus network mode.
DIP Switch (Protocol selection): The Sylk
TM
Bus protocol switch is set to OFF/ON
for 1/2 address.
DIP Switch (Address settings): For the Sylk
TM
Bus device address always
configure “1,2,4 and 8” address. Do not configure “16 to 128” address.
Slide Switch
Dip Switch
Protocols
MAC Address
To Next Page
Loading...
