Using the Security System (cont'd)
29
User Codes
Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to
various features and functions. Tuxedo can hold the identity for 10 Users in its memory. If additional
Users are needed, define the additional Users using the Console Emulation Mode.
Users for the system are programmed in a central user setup location that provides the specific
questions for authorization levels assigned to different users. You may want these users to be the same,
but there are situations in which you may want a user to have limited capabilities. These capabilities
are defined by the Authority Level assigned each user.
Authority Levels
Authority levels define the system functions a particular user can perform. Depending on the authority
assigned to you, there are certain system functions you may be prohibited from performing. The
following information describes the authority levels that can be assigned through the keypad and
provides the equivalent authority level name found in your alarm system manuals. The authority levels
that can be assigned are as follows:
Authority
Level
Functions
Equivalent System Name
Master
Can perform all security functions,
add/delete users in assigned partition,
program scheduled events, and change
partition master code
Partition Master Level 1 Master
Normal Perform security functions (arm,
disarm)
Standard User Level 3 Operator A
Guest
Can arm the system in assigned
partitions, but cannot disarm the
system unless the system was armed
with this code.
Note: Do not assign this level if Quick
Arm is enabled in your system.
Guest Level 4 Operator B
No
Access
Used to restrict access from a partition. N/A N/A
The authorized code for adding users is dependent upon the alarm panel you are interfacing with.
Check your alarm panel Installation and Setup Guide to determine who can add users.
To Next Page
Loading...
Need help?
General
