35
Setup Menus
Your installer has already set up your system, however, if changes are needed, you can change the
settings as described below.
Brightness and Volume Control
From the "Home" screen, press the Setup icon. Move the Brightness/Volume slide bar up or down
to increase or decrease settings. Yes saves the change. No discards the change. If changes are made,
when you exit a pop-up window displays: “Information Settings Saved“
Display & Audio Setup
Display and Audio Setup menus let you access Operating Modes.
Operating Modes provides access to: Chime Mode, Voice Mode, and Voice Chime.
- When in Chime Mode the Keypad chimes whenever a door or window is open.
- When in Voice Mode the Keypad voice annunciates whenever a change in system status occurs such
as Armed, Disarmed, or Alarms.
- When in Voice Chime the chime mode and voice mode are in effect. The chime beeps followed by voice
annunciation.
To change these settings, do the following:
From the "Home" screen, press the Setup icon. Press the Disp & Audio Setup
icon and enter
your Authorized Code, if required. Select Chime Mode or Voice Mode to turn the mode on or off.
Press the HOME or BACK icon after making your selection.
IMPORTANT: The Chime feature is intended for convenience and is not intended for life safety
purposes or pool alarm and does not meet the requirements of UL 2017.
Notes:
• If the Chime Mode and Voice Mode are both selected, the Voice Chime is automatically
selected.
• When the keypad exits the “Operating Modes” screen, your selection is saved.
• It may take a few seconds for the Chime Mode to take effect.
Language Selection (if applicable)
Tuxedo has the functionality to display four different languages including multi-lingual web page
display. Set the language feature as follows:
From the "Home" screen, press the Setup icon. Press the Disp & Audio Setup
icon and enter
your Authorized Code, if required. Press the Language field, and select from English, French Canadian,
Latin American Spanish, or Latin American Portuguese; English is the default.
Note: After the language is selected, a pop-up window displays: “Settings saved language has been
changed, you should reset the system” Select OK; the keypad reverts back to the “Home”
screen with the selected language applied. Select Cancel to cancel the selection.
To Next Page
Loading...
Need help?
General
